IEC 62776 PDF
IEC DOUBLE-CAPPED LED LAMPS DESIGNED TO RETROFIT LINEAR FLUORESCENT LAMPS – SAFETY SPECIFICATIONS. IEC , First edition, *) – Double-capped LED lamps Corrigendum, March till IEC är inarbetat i standarden. Buy IEC Ed. Double-capped LED lamps designed to retrofit linear fluorescent lamps – Safety specifications from SAI Global.
|Published (Last):||27 November 2018|
|PDF File Size:||2.81 Mb|
|ePub File Size:||4.6 Mb|
|Price:||Free* [*Free Regsitration Required]|
The main contents of update. Categories News 20 Achievement 6. The standard is only applicable to LED lamp to meet the following conditions: The requirements in this standard are given for general lighting service excluding for example explosive atmospheres. In the case of doubt based on the inspection of the lamp and the examination of the lamp circuit diagram, and in agreement with the manufacturer or responsible vendor, lamps shall be specially oec so that a fault condition can be simulated and shall be submitted for testing see Clause Following IECSection 8, basic insulation during lamp insertion is sufficient.
BS EN 62776:2015
Scope This International Standard specifies the safety and interchangeability requirements, and the exchange operation together with the test methods and conditions required to show compliance of double-capped LED lamps with G5 and G13 caps, intended for replacing fluorescent lamps with the same caps, having: The publication of this standard gives a suitable safety guide for LED manufacturers exporting to EU market.
Example for a retrofit ie. Recommendations for whole product testing or batch testing are given in Annex A. The requirements of this standard relate only to type testing.
Intertek Total Quality Assurance expertise, delivered 62776 with precision, pace and passion, enabling our customers to power ahead safely. NOTE 1 The rated voltage or voltage range of the lamp can from the open circuit voltage.
Opened lamps or inspection of internal component parts of the lamp may be required to verify conformity with Clauses 11, 12 and 14 of this standard.
The publication of this standard gives a suitable safety guide for LED manufacturers exporting to EU market. Size and gauge requirements: It is then gradually raised to the full value. Further requirements on failing safe are iecc in Clause Variation of dimension A due 6. This standard does not cover iex conversion LED lamps where modification in the luminaire is required.
Such LED lamps are designed for replacement without requiring any internal modification of the luminaire. In cases of doubt regarding the suitability the application the manufacturer of this lamp should be consulted.
We provide safety, performance and energy testing service for all kinds of lighting products used for household, commercial, automobile, airports, traffic and railway, etc. For the replacement of the tube, the LED lamp tube of the interior light of the lamp needs to be changed, which is not within the scope of this standard.
No flashover or breakdown shall occur during the test. Dimension A is measured after the lamp is stabilised and as Aoperating.
NOTE 2 This standard includes photobiological safety. The length of the lamp shall not change significantly within the specified ambient temperature range of the lamp. Such LED lamps are designed for replacement without requiring any internal modification of the luminaire. The content of the instructions shall include the following. Ice assessment project in view of iwc above principles, the standard mainly focuses on the evaluation of: Contact us service.
Intertek is a leading Total Quality Assurance provider to industries worldwide. In Maygeneral safety requirements IEC If lamps are marked with a voltage range, rated voltage is taken as the maximum of the voltage range marked unless the manufacturer declares another voltage as the most critical one.
IEC /ISH – Estonian Centre for Standardisation
Figure 7 — Schematic steps of removing a fluorescent lamp and inserting a double-capped LED lamp designed to retrofit linear fluorescent lamp 5.
The requirements in this standard are given for general lighting service excluding for example explosive atmospheres. Scope — this standard covers only the lamps which are: The marking shall be legible after the test. Free Seminar Guangzhou Important Updates! Labeling requirements are to power ballast lamps?