ASTM D4607-94 PDF
Buy ASTM D() Standard Test Method for Determination of Iodine Number of Activated Carbon from SAI Global. ASTM Designation: D Standard Test Method for. Determination of Iodine Number of Activated Carbon. 1. Scope. This test method covers the. Standard. Standard number, ASTM-D ; ASTM-D Title, Standard Test Method for Determination of Iodine Number of Activated.
|Published (Last):||23 May 2010|
|PDF File Size:||18.93 Mb|
|ePub File Size:||19.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
Specific hazard statements are given in Section 7. Anomalous adsorption of iodine on activated carbon. The carbon dosages used were estimated as follows: Consequently, the investigation into the adsorption of iodine by aastm carbons Bhatia et al.
Preparation and characterization of novel CO 2 molecular basket adsorbents based on polymer-modified mesoporous molecular sieve MCM Commercial activated carbon is interesting due to low-cost and simple availability.
Activated Carbon Applications
The impregnation ration, which was controlled by varying the proportion of H 3 PO 4 used for activation, had a strong influence on the yield of active carbon. Surface and bulk chemistry of charcoal obtained by vacuum pyrolysis of bark: Flow method of adsorption of benzene vapour carbon-black Raven, Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Scanning D467-94 Microscope Studies SEM technique was applied in order to study regarding surface morphology of adsorbent before and after impregnation with chitosan solution.
Sorption of methylene blue by unmodified and citric acid modified sawdust. The major objective of this study was to investigate the adsorption characteristics of active carbons prepared by pyrolysis of bagasse, sorghum and millet straws in ortho phosphoric acid. The straws were cut into pieces of approximately 3 cm to obtain the samples for milling. Except active carbons from millet straws with iodine number ofcarbons from bagasse and sorghum straw gave iodine number within the reported values for carbons from pelletised straws and bagasse, that were activated physically during carbonisation Minkova et al.
The porous texture of the active carbons was characterised by aqueous phase adsorption of iodine and methylene blue. It’s easy to join and it’s free. Structured carbon adsorbents from clay, zeolite and mesoporous aluminosilicate templates.
The Fastest equilibrium was attained in 25 min with the optimum initial adsorbate load of 0. Adsorption of dyes by powdered and granulated activated carbon from coconut shell. The yields of active carbons indicate that the temperature domain in which carbonization occurs depends on the interaction between the furnace residence condition and chemical activation.
High contents of volatile matter Already Subscribed to this document. This article has been cited by other articles in ScienceCentral. If the document is revised or amended, you will be notified by email. Phosphoric acid functions as a dehydrating agent and inhibits the formation of tar Su et al.
The stoppers were loosened to vent the flasks and they were heated to bring the contents to boil for 30 sec. A solid exhibiting favourable adsorption isotherm as well as faster kinetics is supposed to be a good adsorbent.
Attainment of steady equilibrium during pyrolysis was the criteria for selecting the best temperature for the dd4607-94 of active carbons from the precursors. In porcelain crucibles, 0.
ASTM D() – Standard Test Method for Determination of Iodine Number of Activated Carbon
However, it must be realized that any relationship between surface area and iodine number cannot be generalized. In this study, the most interesting adsorbent is granular activated carbon GAC. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
This standard is also available to be included in Standards Subscriptions. Standard practice for determination of adsorptive capacity of activated carbon by aqueous phase isotherm technique.